LG WD-12380TP - Manual (Page 21)

aintenance
^ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
^ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the
door lock to prevent young children being trapped inside.
■ The water inlet filter
-" " error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is therefore a good idea to clean it from time to time.
2 . Unscrew the
water inlet
hose.
4 . Tighten up
the inlet
hose.
■ The drain pump filter
* The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
^ CAUTION First drain using the drain and then open the pump filter to remove whatever
any threads or objects.
Be careful when draining if the water is hot.
1 . Open the lower cover
cap (d)) by using a
coin. Turn the drain
plug ((2)) to pull out
the hose.
2 . Unplug the drain plug (@),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter (®) open to the left.
3 . Remove any foreign material
from the pump filter (@). After
cleaning, turn the pump filter ((I
clockwise and insert the drain
plug ( ® )to the original place,
close the lower cover cap.