Cub Cadet HP LS 27 CC - Manual (Page 16)

16 s
ectiOn
6— M
aintenance
& a
djustMents
Flexible Pump Coupler
The flexible pump coupler is a nylon “spider” insert, located
between the pump and the engine shaft. Over time, the coupler
will harden and deteriorate. If you detect vibration or noise
coming from the area between the engine and the pump contact
an authorized service dealer. If the coupler fails completely, you
will experience a loss of power.
Beam
Lubricate both sides of the beam (where it comes into contact with
the splitting wedge), before each use, with engine oil.
Off-Season Storage
If the log splitter will not be used for more than 30 days, prepare
it for storage as follows:
WARNING! Never store the machine with fuel in
the fuel tank inside of building where fumes may
reach an open flame or spark, or where ignition
sources are present such as hot water and space
heaters, furnaces, clothes dryers, stoves, electric
motors, etc.
Refer to the Engine Operator’s manual packed with your 1.
log splitter for information on the off-season storage of the
engine.
Clean the log splitter thoroughly.
2.
NOTE: The use of pressure washers or a garden hose to
clean the splitter is not recommended. They may cause
damage to the bearings or the engine. The use of water will
result in a shortened life and reduce serviceability.
Wipe the machine with an oiled rag to prevent rust,
3.
especially on the wedge and the beam.
Store the log splitter in a clean, dry area. Do not store it
4.
next to corrosive materials, such as fertilizer.
NOTE: If storing in an unventilated or metal storage shed,
be certain to rustproof the equipment by coating it with a
light oil or silicone.
If necessary Refill the reservoir within range marked on the 11.
dipstick. See Fig. 6-3.
Extend and retract the wedge 12 complete cycles to remove 12.
trapped air in the system (the system is “self-bleeding”).
WARNING! Much of the original fluid has been drawn into
the cylinder and hoses. Make certain to refill the reservoir
to prevent damage to the hydraulic pump. Failure to refill
the tank will void the log splitter’s warranty.
NOTE: Some fluid may overflow from the vent plug as the system
builds heat and the fluid expands and seeks a balanced level. Do
not operate the log splitter without the proper amount of fluid in
the reservoir tank.
Maintain the fluid level within the range specified on the 13.
dipstick at all times. When checking the fluid, always make
sure to tighten the dipstick until the top of the threads are
flush with the top of the pipe.
NOTE: Always dispose of any used hydraulic fluid and
engine oil at approved recycling centers only.
Contaminants in the fluid may damage the hydraulic
14.
components. Flushing the reservoir tank and hoses with
kerosene whenever service is performed on the tank,
hydraulic pump or valve is recommended. Contact an
authorized service dealer.
Hose Clamps
Check the clamps on the return hose before each use and check
the clamps on the suction hose once a season.
Hydraulic Filter
Change the hydraulic filter every 50 hours of operation. Use only
a 10 micron hydraulic filter. Order part number 723-0405.
Dipstick
MIN
Hydraulic Fluid
Only
MAX
Figure 6-3