Alumax 392 - Manual (Page 10)

EPH-N00-06010
5-20-97
Page 10 of 11
19
20
21
Peel off the backing on the A
LUMAX
decal
[HH] and apply to the inside surface of the header.
Trim the flap on the clear vinyl strike jamb seal to
clear the bottom door rail.
Inspect the pieces of black glazing vinyl,
and note the two different profiles. The smaller
shape [JJ] is installed vertically and the larger
shape [KK] is installed horizontally. For struc-
tural strength and maximum water resistance,
these vinyls are designed to fit tightly between the
glass and framing. To speed installation, use
glass cleaner for lubrication and a small block of
wood to press the vinyl into place.
NOTE: These glazing vinyls have been pre-lubri-
cated with a water-based silicone compound. Wash
hands thoroughly after glazing and avoid contact
with eyes or mouth.
Cut four pieces of the smaller vinyl [JJ] 1"
longer than the vertical opening (to prevent gap-
ping from shrinkage) and trim the ends on a 45°
angle. Using the masking tape guides, center the
glass panel [J] in the frame. Cut four short (1" - 2")
pieces of the small vinyl and press into the jamb
and post on each side to hold the glass tempo-
rarily.
Take one of the long pieces of vinyl, and starting
on the outside exterior jamb, press each end into
the frame and work toward the middle. Be careful
not to stretch the vinyl. Install the other three
pieces in a similar fashion.
1/4" GLASS
REQUIRES:
FIXED GLASS PANEL VERTICAL HORIZONTAL
V-219 V-220
3/16" GLASS
REQUIRES:
V-226 V-225
NOTCH NOTCH
STANDARD SIZES
SHIPPED WITH
4 PIECE VINYLS
(TEAR APART)