Alumax 392 - Manual (Page 8)

EPH-N00-06010
5-20-97
Page 8 of 11
13
14
Thread the two #10-24 x 7/16" square head
set screws [W] into the tapped holes in the pivot
blocks [X] (pivot blocks may be pre-assembled).
Slide the pivot blocks into the top and bottom rails
of the glazed door panel [R] with the stainless
steel pins toward the pivot side of the door (see
detail).
Position the pivot pins 1 5/8" from the pivot edge
of the door panel. Tighten the set screws just
enough to prevent the pivot blocks from moving
(finger tight plus a quarter turn). A 1/4" wrench
(not supplied by A
LUMAX
) will fit the set screw
heads.
Press the white nylon spacer [Y] over the bottom
pivot pin on the door panel.
Insert the two nylon pivot bushings [AA]
into the pivot holes in the head and curb fillers [P].
Lift the door panel [R] and insert the top pivot pin
into the pivot bushing in the header filler. Hold
the door vertical and insert the bottom pivot pin
into the pivot bushing in the curb filler. It may be
necessary to remove the header retaining screws
and raise the header slightly to install the door.
When the door has been set into place, snap the
security washer [BB] over the top pivot pin to hold
the upper pivot bushing in place and prevent
accidental dislodging of the door.
15
Slide the door handle [CC] with magnet
onto the strike edge of the door panel [R]. Close
the door and slide the handle up or down until the
two magnetic strips are aligned. Use a pencil or
masking tape to mark the top and bottom edges of
the door handle on the door.
Slip the door handle vinyl [DD] over the door
between the marks and carefully drive the door
handle onto the door panel. Spraying glass cleaner
or water onto the vinyl and handle will make
assembly easier.
Close the door and check the clearance with the
strike jamb. If necessary, loosen the set screws
[W] on the top & bottom pivot blocks [X] and adjust
the door panel to align the strike magnets. When
the door panel is properly aligned, tighten the set
screws securely.