Cobra Electronics 18 WXST II - Manual (Page 16)

16
Maintenance/
Adjustment
Maintenance
Maintenance and Adjustment
Your COBRA CB transceiver is specifically
designed for the environment encountered in
mobile installations. The use of all solid state cir-
cuitry and its light weight result in high reliabili-
ty. Should a failure occur, however, review the fol-
lowing, then if necessary, replace parts only with
identical parts. Do not substitute.
1. Check connections to the source of power and
make sure it is the 13.8 VDC required to oper-
ate your radio.
2. Check the fuses in the DC power cord. The
main power lead (red & orange wire) has a 2
amp 3AG type fuse in its holder. Use only the
above specified type and size fuse for maxi-
mum protection. Failure to do so, will void the
warranty.
3. Make certain the microphone is properly
plugged in.
4. Make certain the antenna is properly assem-
bled and connected.
If you are unable to correct the problem, refer to
the SERVICE INSTRUCTIONS at the end of this
manual for the correct procedure for warranty
and post-warranty service from COBRA.