AVer SPB370 user manual - Manual (Page 26)

E-22
Function Data[0] Data[1] Data[2] CheckSum Code
CAPTURE CONTINUOUS 0x0D 0x01 0x00 0x57
*1 ：CheckSum = 0x0B xor 0x03 xor Data[0] xor Data[1] xor Data[2] xor 0x53
Get Value Format
Send Format
︰
0x52 + 0x0A + 0x01 + Data[0] + 0x53 + CheckSum
Receive Format
︰
0x53 + 0x0C + 0x01 + ReData[0] + 0x53 + ReCheckSum
Function Data[0] CheckSum Code ReData[0] ReCheckSum Code
Red Value 0x02 0x5A Value[0~255] *1
Blue Value 0x03 0x5B Value[0~255] *1
Power Status 0x04 0x5C 0 : OFF 1: ON *1
Lamp Status 0x05 0x5D 0 : OFF 1: ON *1
Display Status 0x06 0x5E
0: Camera Mode
1: Source Input
2: Playback Mode
*1
Video Output
Status
0x07 0x5F 0: VGA 1: TV *1
Freeze Status 0x08 0x50 0 : OFF 1: ON *1
Brightness Value 0x0A 0x52 Value[0~63] *1
Contrast Value 0x0B 0x53 Value[0~255] *1
LIGHT BOX
Status
0x0C 0x54 0 : OFF 1: ON *1
*1 ：ReCheckSum = 0x0C xor 0x01 xor ReData[0] xor 0x52
T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
This section provides useful tips describing how to solve common problems while using
the AVerVision SPB370.
There is no picture on the presentation screen.
1. Check all the connectors again as illustrated in this manual.
2. Check the remote control’s on/off switch on your display output device.
3. Verify the setting of the display output device.
4. If you are using a notebook or computer, you may have to switch the source to
VGA.
5. Make sure the TV/RGB switch is properly set based on your display output.
There is no computer signal on the presentation screen.
When you turn on the computer, it will auto-detect the type of monitor you have. During
auto-detection, there won’t be any display on your presentation screen. To avoid this
problem, connect your computer and all the necessary cables to the AVerVision SPB370
first before you power on your computer.
Unable to capture and save still image or is not responding.
- The message “FULL” is displayed. It means the memory source has reached the
maximum capacity. Just transfer the images to PC or format the memory source.
- The message “SD PROTECT” is displayed. It means the SD card is write protected.
Just remove the SD card from the slot and unlock it.
- The Capture setting could be in Continuous mode and the time interval is very long.
Press MENU > select Capture > Single or change the Continuous mode interval setting.
The picture on the presentation screen is distorted or the image is blurry.
- If the image is blurry or out of focus, press the Auto Focus button to automatically
adjust the focus.
- If the Auto Focus button does not work and still unable to adjust the focus, the lens
motor must be misaligned. Unplug and plug the power to realign the lens motor.