AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 15)

9
Chapter 2 Hardware Installation
2.1 Hard Disk Installation
2.1.1 IWH3216 Touch
The DVR unit can support up to 3 hard disks. The hard disk installation step for IWH3216 Touch is same.Follow the
illustrated instructions below to install the hard disk:
1. Loosen all screws (2 sides and back) and push the
cover backward and lift to open the case cover.
2. Loosen the screws of holder to make hard disk install
more easily.
3. Loosen all the screws of hard disk plate. 4. The hard disk plate can be installed 3 hard disks. User
can choose the position and place the hard disk on it.
5. Turn the plate and hard disk over carefully and
secure the hard disk on the plate. If hard disk cannot
be fit to the screw hole, then, you may adjust the
hard disk position to fit the screw hole.
6. Screw the plate within hard disk inside the DVR unit.
i - User can un-plug the SATA cable of the left side
HDD for screwing plate inside the DVR more
easily later.
- User may manage all power cables and SATA
cables for better connection.