AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 158)

152
Name Function
(17) Temporary
Setting Block
Display the sample settings. Click the sample to apply the setting on the current video.
(18) Status Bar Display the date, and time of the video.
(19) Progress Bar Show the progress of the file being played. You may move the bar to seek at any location of
the track.
(20) iStable To reduce the jolt in the recorded video.(also see Chapter 7.1)
(21) Add Setting Include the new setting to the temporary setting block.
(22) Rename Change the name of the selected setting in the temporary setting block.
(23) Delete Permanently remove the selected setting in the temporary setting block.
(24) Load Setting Call the saved settings.
(25) Save Setting Store the settings in the temporary setting block.
7.1 To Use iStable
The iStable function can reduce the jolt in the recorded video.
1. Click Open File button and select the recorded video.
2. And then, click iStable button.
3. iStable windows will show up.
4. Select the smoothness level – 1(Low), 2, 3, 4, and 5(High). The default value is 3.
5. Click Play button, and then i-Stable function will start to initial the recorded video.
6. When the initialize is done, user will see the original and stabilized recorded video play in two windows.
7. While the video is playing, user can select a portion of video to play and save. Use the Playback Control
buttons or drag the bar on the playback progress bar and pause on where you want to start the cut. Then,
click Segment to set the begin mark. And, Use the Playback Control buttons or drag the bar on the
playback progress bar and pause on where you want to end the cut. Then, click Segment to set the end
mark. To cancel segmentation or set the segment marks from the start, click Segment button again.
8. Click Save Video button to save the wanted clip.