AVer IWH5000 series - Manual (Page 70)

62
4.4 Function Buttons in PTZ Camera Controller
Name Function
(1) Close
Exit PTZ camera controller.
(2) Camera preset
position number
Move the PTZ camera to the preset point.
When user select the preset point 95, a OSD panel will show out and
user can operate PTZ camera through the OSD panel. But preset
point 95 only support for Peloc-D, Peloc-C protocol.
(3) Group AutoPan
Select to automatically operate PTZ camera in group.
(4) Direction buttons’
moving speed
Adjust the moving speed of the PTZ camera lens. This speed will
apply to the (11) Direction buttons ’ moving speed only.
(5) Save Camera
preset position
Save the PTZ camera preset position number. Select the camera and
click the preset position number and save it.
(6) Setup
Configure PTZ cameras (see Chapter 4.6 ).
(7) AutoPan
Operate the PTZ cameras automatically based on the selected
camera group preset position number. User needs to select the (3)
Group AutoPan, then, click (7)Auto Pan button.
(8) Zoom +/-
Zoom in and out the image.
(9) Focus +/- Adjust the focus manually to produce clear image.
(10) Camera ID
Display the PTZ camera number that is being operated.
(11) Direction buttons
Move and position the focal point of the PTZ camera. The support of
direction button depends on the PTZ camera.