CREATIVE 1212M - Manual (Page 13)

2 - Installation
Install the Sync Daughter Card or 0202 Daughter Card
E-MU Digital Audio System 13
E-MU 0202 & AudioDock
If you have both the E-MU 0202 I/O card and the AudioDock, you are advised not to
connect both to the same E-MU 1010 PCI card using this version of software. There are
known issues with doing this what will be addressed in a future software update.
AudioDock Owners only
The AudioDock
requires 1.1 Amps at 12V
(13 Watts) to operate.
The AudioDockM requires
1.25 Amps at 12V (15
Watts) to operate.
5. Locate the Disk Drive Power Converter Cable shown below and identify the large
male connector (the one with pins on it). Plug this connector into a spare disk drive
power cable in your computer. If there is no spare disk drive power cable, insert the
Adapter Cable between one of your disk drives and the power supply.
6. Plug the small connector into the E-MU 1010 PCI card as shown above. The
connector is keyed and can only be inserted one way.
7. After all components have been installed and securely fastened, close the computer
case.
CAUTION: Do not
connect the supplied
CAT5 cable to the
Ethernet or network
connector on your
computer. Doing so may
result in permanent
damage to either your
computer, the E-MU 1010
or both.
8. Connect the supplied network-type cable from the 10 BaseT jack on the E-MU 1010
PCI card labeled “EXTERNAL” to the matching connector labeled “Card” on the
AudioDock. The cable supplied with the AudioDock is specially shielded to prevent
unwanted RF emissions.
9. Plug the power cord back into the wall outlet and turn on your computer.
To Power
Supply
To Disk Drive
E-MU 1010 PCI Card
Power Converter Cable