B&M 64511 TV CABLE ADAPTER - Manual (Page 2)

STEP 5. Install and tighten the supplied "bolt, washer, and nut" through the "TV corrector lever" slot and indicated
"bolt hole" and then fully tighten the "throttle cable stud".
STEP 6. Attach both the TV cable and the throttle cable and adjust as needed.
Note: Some hole diameters in the linkage plate may need to be opened by drilling. This kit was designed for carbure-
tors that use a clip-on throttle cable stud. If your caburetor uses a ball type throttle cable stud, it will require a ball
type stud with longer threads. These can be found at most performance shops. The TV cable stud provided in this
kit is for 6mm TV cable clips. If your TV cable uses a 5/16" clip, it will require enlarging the clip to fit the TV cable
stud.
Edelbrock Carburetor
Nut
Lock Washer
Shim
Throttle Cable Stud
Linkage plate
Lock Nut
TV stud
TV Corrector Lever
Bolt
Washer