B&M 70391 DEEP PAN, 2010+ CAMARO (6L80) - Manual (Page 4)

Figure 7 Figure 8
Figure 9 Figure 10
D. Allow the engine to idle
for at least 1 minute.
STEP 17. CAUTION!: THE ENGINE
MUST BE RUNNING AND TFT
WITHIN THE RANGE AS STATED
ABOVE when the transmission fluid
level is checked:
- Method A (preffered):Using the pre-
viously installed B&M 6L80 Locking
Dipstick P/N 22168 unscrew the dip-
stick cap and check the transmission
fluid level according to the instructions.
Add (see step 14) or remove fluid (use
drain plug or oil level check plug) ac-
cordingly.
-Method B: Carefully raise and sup-
port the vehicle (with the engine still
running and TFT in range). Ensure the
vehicle is level. Remove the oil level
check plug from the pan and allow any
fluid to drain until the fluid begins to
drip. If no fluid comes out, add fluid
as described in step 14.
WARNING!: An under-filled trans-
mission will cause premature com-
ponent wear and damage. An
over-filled transmission will cause
fluid to discharge out the vent tube,
fluid foaming, and/or pump cavi-
tation. DO NOT operate the vehicle with an incorrect transmission
fluid level.
STEP 18. Inspect the pan gasket and
any of the ports for any signs of leaks
and correct immediately before oper-
ating vehicle.
STEP 19. Reset the oil life monitor in
the DIC.
STEP 20. Over the next several
cycles of vehicle operation inspect
the transmission, pan, and ports for
any signs of leaks and periodically
check the transmission fluid level as
described in steps 16 & 17.