B&M 81011 MANUAL STREET ROD SHIFTER, 15 TALL STICK - Manual (Page 5)

STEP 11. Measure the distance between the small hole in the
Selector Lever and the small hole in the Transmission
Lever and subtract 1-3/4". NOTE: Make sure the Shifter
is in the "PARK" position (all the way forward) and the
transmission lever is in the "PARK" position as well (all
the way back).
STEP 10. Install the Selector Lever onto the Shifter pivot at a
position of approximately 4:30 in the "PARK" position
(shifter stick moved all the way forward). Use the 1/4-
20x1-1/2" screw, 1/4" flat washers (2), 1/4" lock washer,
and 1/4-20" nut to secure the Selector Lever.
STEP 9. Install the supplied Transmission Lever onto the trans-
mission selector shaft (the lever should be pointing up and
towards the rear of the transmission when in park). Also
note that the Transmission Lever should be installed
angled in towards the transmission.
STEP 12. Cut the supplied Threaded Rod to resulting length in
the previous step.