CASO Germany TMCG 25 chef touch - Manual (Page 73)

caso TMCG25 Chef Touch 73
12.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program.
Press the button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E02 Technical error
A technical error has occurred. Press the button to acknowledge this
fault. Please contact our Customer Service.
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme. Press the button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.
12.3 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error Possible cause Action
The selected program will
not start.
Device door is not closed Close device door
Power plug is not plugged in Plug in mains plug!
Fuse is not activated Activate fuse
The turntable turns
jerkily.
Dirt between the turntable and
the base of cooking camber
Remove dirt
Dirt on rolling ring
Cooking vessel too large Use different cooking vessel
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
Incorrectly selected time or
power level Re-set time and power level
Repeat process