CASO Germany Scale X3 - Manual (Page 23)

caso Waage X3 23
13.3.4 Countdown Timer setting
The system is under the state of time (TM-Mode). Press
„MODE“ to enter countdown timer setting state, „TMR” will
appear on the display.
Press “MODE” until the seconds will twinkle on the display, then
press „Unit“ slightly to setup the seconds.
Press „MODE”, the minute will twinkle on the display. Press
„Unit“ slightly, setup the minutes.
After finishing the setting, press „MODE“, to count the time.
After finishing the countdown “00:00” will appear on the LCD
display.
An alarm signal is send out. Press “MODE” slightly to stop the
alarm.
Then press „MODE“ and return to the state of time.
To set the timer back to zero, press „Unit“ for a while.
13.3.5 Unit Exchange
Press the key „Unit“ you can select between „g“ and „oz“.
13.3.6 Over Load Indicator
When the scale is overloaded, „Err“ will appear on the display.