Catler TS 8011 - Manual (Page 12)

10
OPERATING YOUR TS 8011 TOASTER
4. The Lift & Look button surround will
illuminate in blue allowing you to check
on the toasting progress and, if necessary,
cancel the cycle by pressing TOAST/CANCEL
button when the desired toast colour is
achieved.
5. Approximately 10 seconds before the end
of the selected browning setting, the Lift &
Look button will cease illumination. As the
toasting stops and the carriage rises, the
TOAST/CANCEL button surround will flash
and the LED toasting progress indicator will
cease flashing. The LED toasting progress
indicator will re-illuminate to the previously
selected browning setting.
6. Once the toasting cycle has finished and the
carriage has risen and locked into the raised
position, the toast ready alert will sound.
Remove the toast. The TOAST/CANCEL
button surround will re-illuminate in blue for
up to 30 seconds, ready for the next toasting
cycle. The DEFROST button surround will
remain illuminated and should be pressed
once to cancel if a subsequent toasting
function is required. The DEFROST button
surround will cease to illuminate after 30
seconds or when the appliance is switched
off at the power point.
Innovative LIFT & LOOK feature
This feature automatically raises and lowers
the carriage so you can check progress without
interrupting and/or cancelling the toasting
cycle.
To select this feature:
1. The Lift & Look button surround will
illuminate in blue during the toasting cycle
and when using the A BIT MORE, CRUMPET
and DEFROST features. You can press the
Lift & Look button during toasting cycle
to view the toasting progress. If selected,
the Lift & Look button surround will flash.
The LED toasting progress indicator
will cease to flash indicating that the
selected toasting cycle time has not been
interrupted.
When the Lift & Look cycle has finished, the
toasting cycle will re-commence, indicated
by the resumed flashing of LED toasting
progress indicator.
2. Approximately 10 seconds before the end
of the selected browning setting, the Lift
& Look button will cease illumination and
cannot be activated in this time.
Using the Bun Rack
Place the bun warmer rack onto the slots at the
top of the toaster, ensuring it is securely placed.
Set the browning control to setting ´1´ only.
Press the TOAST/CANCEL button to start. Wait
for the toaster to switch off automatically, or
press the TOAST/CANCEL button to switch the
toaster off before removing the buns. Repeat
the operation again if desired brownness is
needed. Take care not to touch the metal parts
of the bun rack as this will be hot.