Catler TS 8011 - Manual (Page 9)

OPERATING YOUR TS 8011 TOASTER
77
OPERATING YOUR TS 8011 TOASTER
Before first use, remove any packaging material
or promotional labels attached to your toaster.
1. Insert the power plug into a 230/240 V
power outlet then turn the power on.
The TOAST/CANCEL button surround
will illuminate in blue. The LED toasting
progress indicator will illuminate in blue
from left to right and then align to the
selected browning setting (indicated by the
position of the browning control slide). The
toaster will revert to standby mode after
30 seconds if a button is not pressed or the
browning control slide is not adjusted.
NOTE:
When using the toaster for the first
time, we suggest toasting on the
maximum setting without bread.
The toaster may emit a thin smoke
or distinct odour on initial use. This
is normal and not detrimental to the
performance of the toaster.
2. Place one slice of bread, one crumpet or
half an English muffin or half a bagel only,
into each of the toasting slots. Ensure items
for toasting are not too large or too thick to
fit in the toasting slots.
The TS 8011 has dual independent
controls allowing each pair of slots to work
independently so you can simultaneously
toast to different preferences.
3. Select the desired browning setting by
adjusting the browning control slide on the
front of the toaster. The browning settings
range from ‘1’ (lightest) to ‘5’ (darkest).
The LED toasting progress indicator will
illuminate in blue and align to the selected
browning setting (as indicated by the
position of the browning control slide).
NOTE:
When using the toaster for the first
time, it is suggested to toast on
browning setting ‘3’. Various types of
bread and personal preference may
require a different browning setting.
For example, raisin toast and white
light-textured breads may require a
lighter setting, whilst heavier textured
rye breads may require a darker setting.
4. To start the toasting process, press the
TOAST/CANCEL button on top of the
toaster. The TOAST/CANCEL button
surround will illuminate in red and the
carriage will automatically lower into the
toasting slots which start the toasting cycle.
As the carriage automatically locks into
position, the Lift & Look button surround
will illuminate in blue and the LED toasting
progress indicator (above the selected
browning setting) will flash and start to
gradually count down (towards the left)
indicating the toasting progress.
5. The Lift & Look button can be pressed
up until 10 seconds before the end of
the toasting cycle to view the browning
of the bread. When selected, the Lift
& Look button surround will flash and
the LED toasting progress indicator
will remain steady (indicating that the
selected browning setting has not been
interrupted by the carriage rising). The
toasting recommences immediately as the
carriage lowers and locks into position,
and as indicated by the Lift & Look button
surround illuminating and the LED toasting
progress indicator flashing.
DO NOT LEAVE THE TOASTER UNATTENDED WHEN IN USE AS TOAST MAY JAM. IN THE UNLIKELY EVENT THAT BREAD, CRUMPETS OR
MUFFINS BECOME JAMMED IN THE TOASTING SLOTS, ALL THE BUTTONS AND THE LED TOASTING PROGRESS INDICATOR WILL FLASH
AND THE ELEMENTS WILL TURN OFF. SWITCH THE TOASTER OFF AT THE POWER OUTLET, REMOVE THE POWER PLUG AND ALLOW
THE TOASTER TO COOL COMPLETELY BEFORE CAREFULLY EASING THE BREAD OUT OF THE SLOTS. TAKE CARE NOT TO DAMAGE THE
ELEMENTS.