CDI Torque COMPUTORQ II Electronic Torque Wrench - Manual (Page 2)

SAFETY MESSAGES
WARNING - Risk of flying particles
Over-torquing can cause breakage. Force
against flex stops on flex head can cause
head breakage. An out of calibration angle
wrench can cause part or tool breakage.
Broken hand tools, sockets or accessories
can cause injury. Excess force can cause crow
foot or flare nut wrench slippage.
READ THIS MANUAL COMPLETELY BEFORE
USING THE CDI COMPUTORq II WRENCH
• To insure accuracy, work must not move in
angle mode.
• For personal safety and to avoid wrench
damage, follow good professional tool and
fastener installation practices.
• Periodic recalibration is necessary to
maintain tool accuracy.
USERS AND BYSTANDERS SHOULD ALWAYS
WEAR EYE PROTECTION
• Be sure all components, including
adapters, extensions, drivers and sockets
are rated to match or exceed the torque
being applied with tool.
• Observe all equipment, system and
manufacturer’s warnings, cautions and
procedures when using this wrench.
• Always use the correct size socket for the
fastener being torqued.
• Do not use damaged sockets, showing
signs of wear or cracks.
• Always replace damaged fasteners before
applying torque.
WARNING - To avoid damaging Computor II
Wrench
• Never operate wrench when powered OFF.
Always power wrench ON prior to applying
torque.
• Do not press ON key while torque is being
applied.
• Never use this wrench to loosen fasteners.
MAINTENANcE / SERVIcE
1. IMPORTANT - Service, repair and calibration are
to be performed by CDI Torque Products only.
Calibration by the user is recorded in the wrench
and voids factory certification.
2. The torque wrench’s internal mechanism is
permanently lubricated during assembly. Do not
attempt to lubricate the internal mechanism.
3. To safely clean the torque wrench, wipe with a damp
cloth. NEVER use solvents, thinners, or engine
cleaners of any kind. NEVER immerse the torque
wrench in liquids of any kind.
4. Store torque wrench in protective tube at its lowest
torque setting. Do not force handle below lowest
setting.
• Never use extensions, such as a pipe, on
the handle of the wrench.
• Always make sure the ratchet Forward/
Reverse Switch is fully engaged in the
correct position.
• Always verify that the wrench capacity
matches or exceeds each application before
proceeding.
• Always verify the calibration of the wrench
if you know or suspect its capacity has been
exceeded.
• Never force the head of flex head drives
against stops.
• Always pull - do not push - on the wrench
handle and adjust your stance to prevent a
possible fall while applying torque.
WARNING - Electrical Shock Hazard
• Electrical shock can cause injury.
• Plastic handle is not insulated.
• Do not use on live electrical circuits.
SAFETY MESSAGES
WARNING
CAUTION
CLOTHING
DONOTCR DONTPULL
EARPROT DUSTMASK
DRWSTEP EXTENDER
NO OVERTORQUE
EYEPROTEC FACESHLD FILTMASK
FIRE FALLING GEARS
HAMRON HAMMER2
WEARGLV
XPLOSION VIBRATE
TIPOVER
SHOCK
PRYING PRWDRIVR
INFO SOLID CIRCLE
TRIANGLE
DANGER
C0 MASK NEEDED
TIP OVER CHILD