BoonDocker KAWASAKI KX: 450 User Manual
Page 3
Revised 1/23/2014
Page 3 of 6
www.boondockers.com……………….....
……….………………....877-522-7805
7. Drill 3/4 hole size on left of rear fender to fit
feed line through
8. Drill 2 13/64 size holes to fit a zip tie through
to mount boost solenoid. Make sure the seat &
all related parts will clear the lines & solenoid.
9. Install oil filter cover. Make sure the filter is
installed correctly. Install oil pressure feed line
Route through frame and manifold as shown.
10. Install oil drain line. Install 2 oil seal rings
between stator cover & banjo fitting on the Mag
cover for sealing purposes and mount hose loom
clamp on transmission housing as shown.
11. Install exhaust inlet with clamp. Leave loose
for fitting purposes.
12. Mount turbo. Actuator bracket hooks to left
side of sub frame. You possibly will have to
loosen the actuator nuts for fitting purposes.