BoonDocker POLARIS: 700/800 IQ Dragon Plug & Play - Manual (Page 3)

BoonDocker – 1585 Hollipark Dr. Idaho Falls, ID 83401 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 1-16-08 Page 3 of 13
III. Control Box Mounting Locations
The Control Box can be mounted under the hood, on the dash, or on the handlebar riser using the supplied Velcro strips.
Before applying the adhesive strips, thoroughly clean each surface (rubbing alcohol works well). It is also best if each
surface is room temperature.
If the box is mounted under the hood, keep the box away from excess heat (like the exhaust), and away from the ignition
coils.
Note: The Control Box is designed to be splash proof. Do not submerge or subject the box to high-pressure spray.
IV. Battery / Jumper Connectors
Two jumpers are supplied with the Control Box:
1. Battery Connector
The Control Box is designed to operate without a battery – the box will
turn itself on whenever power is applied for the fuel injectors. However,
a 9-volt battery (not included) can be plugged into the box through the
Control Box’s connectors with the supplied Battery Connector in order
to operate the box without the sled running.
2. Jumper Bypass Connector
The Jumper/Bypass connector can be used to bypass the Control Box in
case the sled needs to be run without the Control Box. Disconnect the
Control Box from the EFI harness and plug in the Jumper connector - the
injectors are now connected directly to the sled’s ECU.
V. Control Box Operation
The control box is powered only when the injectors are on which occurs for a few seconds when the key is first turned on
and when the engine is running. Up to 5 different maps are stored in the box (currently all with zero values). The box will
remember what map was last selected and what its settings are – you do not need to do anything to save a map.
1. Startup Screen
When the box is first turned on (by the engine or battery), the Intro screen is displayed. Press any key to go to the
main menu. An example Intro screen display is shown below:
Polaris 700Turbo
Ver:5.1
In the example shown above, this screen displays the following information:
Polaris700
Sled model. This box is designed for the Polaris 700 Turbo. Boxes for other sleds will have
other lettering.
Ver: 5.1
This is the software version of the box. The box can be reprogrammed only by sending the
box back to Boondocker
2. Main Menu
The Main Menu is shown below:
Main
Æ
Fuel Stats
Menu N2O Map1U