BoonDocker Adjustable Actuator - Manual (Page 2)

Adjusting your Adjustable Actuator
With the Base Plate bolted to the actuator bracket this is now fixed. With your pressure line on the
Actuator Head assembly it is now basically in a fixed position and cannot turn. To increase your
minimum boost pressure you will turn the knurled Actuator Drive toward the Actuator Head
Assembly, away from the Actuator Base Plate while holding the Actuator Head Assembly. This
increases tension on the spring without changing the rod length to the waste gate.
Note: The overall length of the actuator will not change as the spring pressure is increased.
This photo represents an Adjustable
Actuator that is adjusted to a minimum
boost setting.
This photo represents an Adjustable
Actuator that is adjusted to a maximum
boost setting.
Page 2