Code 3 950 Series Software - Manual (Page 7)

Take Down and Alley Light Modules:
Selecting Flash Patterns:
The Take Down and Alley Lights can be programmed to fl ash at different rates.
NOTE: Certain rates are designed for use with LED/TriCore® Take Down or Alleys and may not work well with
Halogen Lamps.
STEP 1:
Power-up the light bar. Select the Take Down Flash Mode (BLK) or the Alley Flash Mode (BLU/WHT) by applying +power
to the appropriate wire. Programming will not work if more than one function is selected at a time.
STEP 2:
Continue applying power to the wire from Step 1. Refer to Table 7 for the available fl ash patterns.
To increment to the next pattern, momentarily hold the BLK/RED wire to +power for less than two seconds and then
release. The four corner light heads will turn on steady to indicate that the pattern has been incremented.
To decrement to the previous pattern, momentarily hold the BLK/RED wire to +power for two to four seconds and
then release. The four corner light heads will turn on steady and then turn off to indicate that the pattern has been
decremented.
After the pattern selection wire has been released, the new pattern will begin to fl ash and is automatically stored each
time.
NOTE: To restore the Factory Default Take Down and Alley Flash Patterns, hold the BLK/RED wire to +power for
more than four seconds. The four corner light heads will turn on steady, turn off and then turn on steady again
to indicate that the Factory Default Take Down and Alley Flash Patterns have been restored. The default fl ash
pattern for Take Down and Alley Lights is Medium Single 115FPM.
STEP 3:
Repeat steps 1 through 2 for the Take Down Flash Mode or the Alley Flash Mode as desired.
TABLE 7: TAKE DOWN AND ALLEY FLASH PATTERNS
PATTERN NUMBER PATTERN DESCRIPTION
1 FAST QUAD 80FPM
2 SLOW QUAD 60FPM
3 FAST SINGLE 375FPM
4 MEDIUM SINGLE 115FPM *
5 SLOW SINGLE 60FPM *
6 FAST DOUBLE 115FPM
7 SLOW DOUBLE 60FPM *
8 FAST SIX 80FPM
9 SLOW SIX 60FPM
10 VARIABLE RATE SINGLE
11 NFPA QUAD 75FPM
12 CYCLE FLASH
*Patterns that work with Halogens and LED/TriCore® Light Heads.
All other patterns are intended for use with LED/TriCore® Light Heads only.
7