Code 3 950 Series Software - Manual (Page 8)

Secondary Take Down And Alley Light Modules:
Selecting Secondary Take Down and Alley Light Functions:
If the light bar is confi gured with Multi-Color lightheads in the Front, the Front Cut wire (GRN/WHT) can be confi gured to
activate the Front Multi-Color lightheads in a Secondary Take Down mode (see Table 8).
If the light bar is confi gured with Multi-Color lightheads in the Corners, the Rear Cut wire (BLU/BLK) and the Cruise wire
(GRN) can be confi gured to activate the Corner Multi-Color lightheads in a Secondary Alley Light mode. In addition the
Cruise wire (GRN) can be confi gured for multiple Cruise functions. The Rear Cut can operate Secondary Right Alley
lights and the Cruise can operate Secondary Left Alley lights. SeeTable 9 for Rear Cut Functions and Table 10 for Cruise
functions.
NOTE: If the Front Cut wire (GRN/WHT) is confi gured to activate the Front Multi-Color lightheads as Secondary
Take Downs, the standard Front Cut function will be disabled. If the Rear Cut wire (BLU/BLK) is confi gured to
activate the Corner Multi-Color lightheads as Secondary Alley Lights, the standard Rear Cut function will be
disabled. If the Cruise wire (BLU/BLK) is confi gured to activate the Corner Multi-Color lightheads as Secondary
Alley Lights, the standard Cruise function will be disabled.
STEP 1:
Power up the light bar. Select the Front Cut function (GRN/WHT) or the Rear Cut function (BLU/BLK) or the Cruise
function (GRN) by applying +power to the appropriate wire. Programming will not work if more than one function is
selected at a time.
NOTE: If the Front Cut wire (GRN/WHT) is confi gured for the Front Cut function, no lightheads will be activated
when +power is applied to the GRN/WHT wire. If the Rear Cut wire (BLU/BLK) is confi gured for the Rear Cut
function, no lightheads will be activated when +power is applied to the BLU/BLK wire.
STEP 2:
Continue applying power to the wire from Step 1. Refer to Table 8 for the available Front Cut functions, Table 9 for the
available Rear Cut Functions or Table 10 for the available Cruise Light functions.
To increment to the next function, momentarily hold the BLK/RED wire to +power for less than two seconds and then
release. The four corner light heads will turn on steady to indicate that the function has been incremented.
To decrement to the previous function, momentarily hold the BLK/RED wire to +power for two to four seconds and
then release. The four corner light heads will turn on steady and then turn off to indicate that the function has been
decremented.
After the BLK/RED wire has been released, the new function will begin to operate and is automatically stored each time.
NOTE: To restore the Factory Default Secondary Take Down and Alley Light Functions, hold the BLK/RED wire
to +power for more than four seconds. The four corner light heads will turn on steady, turn off and then turn
on steady again to indicate that the Factory Default Secondary Take Down and Alley Light Functions have been
restored. The default function for the Front Cut, Rear Cut and Cruise wires is function number 1 as shown in
Tables 8, 9 and 10.
STEP 3:
Repeat steps 1 through 2 for the Front Cut function, Rear Cut function or Cruise function as desired.
8