Code 3 LED X Exterior Lights - Manual (Page 7)

Note: It is possible to tie the red wires from both modules, and the black wires
from both modules when wiring the dual modules, provided that a properly
sized wire is used for the common connection. The white wires should not
be wired together if independent programming of the two heads is desired.
Wiring:
Flashing Models:
Both single and dual LED-EX modules are equipped with a 8" long 3-wire cable harness
(two for dual modules). The user is required to furnish terminals to attach wires to meet
specific requirement.
Connect wires as follows:
1. Red wire: Power wire, connect to +12V (+24V for 24 volt version) voltage
line.
2. Black wire: GND wire, connect to ground terminal.
3. White wire: Control wire, may be left unconnected. It can also be connected to
GND through a momentary push-button switch, and be used for
programming the operation mode.
Note: The white wire should NOT be connected to a positive voltage
under any circumstances.
Note: The +24V versions will have a 24 volt label designating the unit for
operation on a +24 volt electrical system. The label will typically be
located on the back of the unit.
WARNING!
! If the product is to be used inside the vehicle, it may cause severe personal
injury if not properly mounted and secured. Objects used in vehicle may
become airborne during a collision or other sudden changes in vehicle
speed or direction, such as braking, acceleration or turns.
7