Code 3 PSE LED F12 LED Output Flashers - Manual (Page 2)

2
ELECTRICAL SPECIFICATION
Input Voltage Range +10 Vdc to +16 Vdc
Output Drive Current 3 Amps per Output
Operating Temperature -40 C to +85 C
Flash Patterns Quint, Quad, Triple, Double,
180 fpm Alternating Single,
120 fpm Alternating Single,
120 fpm Simultaneous Single,
90 fpm Alternating Single,
90 fpm Simultaneous Single,
75 fpm Alternating Single,
75 fpm Simultaneous Single,
Cycle Flash
Output Drive Method High-side switched
Pattern Control Method 2 Serial Programming
inputs, 2 Group Select
inputs
Standby Current <10mA @ 12.8 Vdc
Reverse Polarity Protection Yes
Short Circuit Protection Yes
Thermal Protection Yes
MECHANICAL SPECIFICATIONS
Weather resistance Potted to protect circuitry, but not
waterproof
Dimensions 6.0" x 3.6" x .75"
Figure1
WARNING
This Flasher is NOT waterproof!! This
unit must be installed in a location
protected from the environment.
Figure2
The device is designed to flash
Code 3
® 12 volt LED-EX Light up to
3 amps load per output. DO NOT
connect more than a 3 amp
load(two single LED-EX
equivalent) to the output. Doing
so will shut the unit down to
prevent damage to the Flasher.
WARNING
This device is intended for use with LED Lights ONLY!! Use of this product
on an Incandescent, Halogen or any light source other than LED's may
damage the unit and void the warranty.
The use of this or any warning device does not insure that all drivers can or
will observe or react to an emergency warning signal. Never take the right-
of-way for granted. It is your responsibility to be sure you can proceed
safely before entering an intersection, driving against traffic, responding at a
high rate of speed, or walking on or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct
mounting and wiring. Read and follow the manufacturer's instructions before
installing or using this device. The vehicle operator should insure daily that all
features of the device operate correctly. In use, the vehicle operator should
insure the projection of the warning signal is not blocked by vehicle
components(i.e., open trunks or compartment doors), people, vehicles, or
other obstructions. This equipment is intended for use by authorized
personnel only. It is the user's responsibility to understand and obey all laws
reguarding emergency warning devices. The user should check all appli-
cable city, state and federal laws and regulations.
Code 3, Inc., assumes no liability for any loss resulting from the use of this
warning device. Proper installation is vital to the performance of this warning
device and the safe operation of the emergency vehicle. It is important to
recognize that the operator of the emergency vehicle is under psychological
and physiological stress caused by the emergenct situation. The warning
device should be installed in such a manner as to A) Not reduce the output
performance of the system,
B) Place the controls within convenient reach of the operator so that
he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages
and/or currents. Properly protect and use caution around live electrical
connections. Grounding or shorting of electrical connections can cause
high current arcing, which can cause personal injury and/or severe
vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN
THE
PROPER USE OF EMERGENCY WARNING DEVICES IS ESSENTIAL TO
INSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE PUBLIC.