Code 3 SmartPro - Manual

SmartPro Installation Manual
1. Connect flash drive to the computer’s USB port.
2. Install the programmer interface driver first.
a. If your computer is x64 then you must install the x64 version of VCP.
b. If not, then install the other VCP version.
3. Then run the code3_configuration_interface-x.x.x.x (latest version) executable next.
4. Follow the prompts on the screen to complete the installation.
5. You can now run the Configuration Executable.
6. Follow the directions on the Code 3 Interface document.
For further questions, please contact our Technical Hotline @ (314) 966-2800.