Coral Industries Steam Bypass - 2SR1-G - Manual (Page 2)

2SR1-G 11/05
Measure wall to wall at tub level and cut sill (A) to that
measurement.
Slide vinyl track guide (V) into small groove on upright
of sill. Trim ends flush with ends of sill.
Locate center of sill. Position guide (G) at center of sill
with curved leg fitting over curve of sill, and back of guide
fitting under small lip on back upright of sill.
Position 1/8" drill bit in small groove on curved leg of
guide. Drill through guide into sill and secure guide to
sill with 8A x 3/8" pan head screw (M).
INSIDE OF BATH
Measure
Sill
A
Guide
G
Vinyl Track
Guide
V
8A x 3/8" Pan
Head Screw
Sill
A Place guide
at center of sill
M
1 Sill
(A)
/ Guides
(V, G)
CROSS SECTIONS
Your unit has vertical and
horizontal vinyl seals
pre-installed in the door
panels. Door panels
should be installed with
the horizontal vinyl seals
in the top channels
facing the outside (roller
track side) of header.
Vertical vinyl
seals face
legs of jambs.
Vertical vinyl seals
face each other at
the center of unit.
Jamb
Towel Bar
Door Panel
Jamb
Towel Bar
Door Panel
Due to the manufacturing process, there may be
rack marks present at one end of your sill and
header. Sill and header must be trimmed to fit your
individual opening. When cutting sill and header,
make certain to trim off end with rack marks.
HORIZONTAL CROSS-SECTION
Before starting installation of your new enclosure, carefully read all instructions
and lay out parts to become familiar with their identity.
USE OF ANCHORS
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure
to a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with
an 1/8" drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes
in the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors
into the holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal
and bath meet. If desired, caulk inside of enclosure where jambs meet walls.
C leaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.
VERTICAL CROSS-SECTION
Horizontal
vinyl seals
face legs of
header.
(Towel bar
will install on
same side.)