Coral Industries Steam Bypass - 2SR1-G - Manual (Page 4)

2SR1-G 11/05
Rollers are to be installed on the same side of door
panels as horizontal vinyl seals and towel bars.
Mount rollers (J) to top channel of doors at the midpoint
of slots using 8-32 x 3/8" truss head screws (K).
Rollers may be positioned up or down in slots to adjust
for out of plumb situations.
Lift inside door panel into header with towel bar facing
inside of bath. Seat rollers on roller track while guiding
bottom of door into sill guide.
Repeat for outside door, hanging panel with towel bar
facing outside of bath.
Seal unit by caulking along outside of enclosure where
metal and bath meet, especially where sill and tub
meet. If desired, caulk inside of enclosure where jambs
meet walls.
K
8-32 x 3/8"
Truss Head
Screw
Roller
Inside
Door
Panel
Inside
Door
Panel
Header
Header
Outside
Door
Panel
Sill
OUTSIDE
OF
BATH
OUTSIDE
OF BATH
Door
Panel
C
C
5 Towel Bar
(D)
/ Bracket Kit
(F)
Slide sleeves from towel bar bracket kit (F) onto towel
bar brackets. Insert towel bar brackets into each end
of towel bar (D).
Mount towel bar and pull/stop (F) to door panel using
8A x 1 1/4" flat head screw (F). Place pull/stop label in
recessed area of pull/stop, covering screw head. On
opposite end of towel bar, mount bracket to door panel
using 8A x 1" pan head screw.
Repeat for remaining panel.
Mount towel bars on same side of door panels as
horizontal vinyl seals in top channels. Mount pull/stops
on edge of panel closest to jambs.
8A x 1"
Pan Head
Screw
Towel Bar
Bracket
Towel Bar
Bracket
Sleeve
Towel Bar
F
8 Caulking
7 Hanging Door Panels
6 Rollers
(J)
A
J
Vertical Seal
Horizontal
Vinyl Seal
Horizontal
Vinyl Seal
Guide G
Jamb
B
A Sill
Caulk where
metal and
bath meet.
If desired, caulk
inside of enclosure
where jambs meet
bath.
Horizontal
Vinyl Seal
Horizontal
Vinyl Seal
OUTSIDE OF BATH
D
F
F
Pull /
Stop F
F
8A x 1 1/4"
Flat Head
Screw
Pull / Stop
Label
F