Coral Industries Freestyle Bypass (1/4 Frameless) - 2FG1-G - Manual (Page 2)

2FG1-G 3/06
Before starting installation of your new enclosure, carefully read all instructions
and lay out parts to become familiar with their identity.
USE OF ANCHORS
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure to
a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with an 1/8"
drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes in
the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors into
the holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal and
bath meet. If desired, caulk inside of enclosure where jambs meet walls.
C leaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.
Measure
Sill
A
8A x 3/8" Pan
Head Screw
Guide
G
V
L
Vinyl
Track
Guide
INSIDE OF BATH
1 Sill
(A)
/ Guides
(V, G)
Due to the manufacturing process, there may be
rack marks present at one end of your sill and
header. Sill and header must be trimmed to fit
your individual opening. When cutting sill and
header, make certain to trim off end with rack
marks.
Measure wall to wall opening at tub level and cut sill (A)
to that measurement.
Slide vinyl track guide (V) into small groove on upright
of sill. Trim end flush with edge of sill.
Locate center of sill. Position guide (G) at center of sill
with curved leg fitting over curve of sill, and back of guide
fitting under small lip on back upright of sill.
Position 1/8" drill bit in small groove on curved leg of
guide and drill through guide into sill. Secure guide to sill
with 8A x 3/8" pan head screw (L).
Midpoint
of sill