Cuddeback C1000 - Manual (Page 13)

Longest Battery Life Fastest Trigger Time
Page 25 of 37
ii. Displayed as [Clear All Events?] on line 1, and
[C = Yes] on line 2
iii. If you press the (C KEY) the events will be cleared.
iv. If you do not want to clear all the events press any other
key.
2) Viewing Events
a. Events can be viewed from the [Events Saved] display be
pressing the UP KEY or the DOWN KEY.
b. Events are displayed in the following format:
i. Top line of display will show [Event <number>] for
a few seconds, then switch to show the date of the event.
ii. Bottom line of the display will show the time of the event.
iii. To clear this events press the (C KEY). As an event is
being cleared a progress counter will be displayed, you
must wait until this is finished before you can perform
additional operations. Depending upon the number of
events saved it can take up to 45 seconds to clear an
event.
iv. To display the next event press the (UP KEY).
v. To display the previous event press the (DOWN KEY).
vi. Pressing and holding the (UP KEY) or (DOWN KEY)
will advance the displayed event by 10. This allows you
to rapidly access events.
vii. To return to the [Events Saved] display press the (M
KEY).
Mode:Operate
Cuddeback has four operating modes: STANDBY, TEST, LIVE CAMERA, or
DISARMED. Pressing the (UP KEY) or (DOWN KEY) will cycle through the
various operating states.
1)
Standby On – In this mode Cuddeback will not trigger the camera. This
state is used when you are programming and viewing events. Cuddeback
will automatically activate Live Camera mode if left in the Standby
Mode.
2)
Test Mode – Cuddeback is in test and align state. In this mode the
Cuddeback LED will illuminate when activity is sensed. This state is used
to verify Cuddeback’s detection zone and to assist in aligning Cuddeback to
trigger where you desire. Cuddeback will automatically activate Live
Camera mode if left in the Test Mode.
Longest Battery Life Fastest Trigger Time
Page 26 of 37
3) Live Mode – Cuddeback is placed in Live Camera mode and will trigger
the camera when activity is sensed. It is only in this state that the
Cuddeback will save events and trigger the camera. Line 2 of the LCD will
display the programmed camera mode as either Motion, TimeLpse, or
Both. (Refer to the section Setup, Camera Mode for details on the camera
operating mode).
When Live Camera mode is initiated there will be a 45 second delay before
the motion sensor activates. This provides you with enough time to replace
the battery cover and move away from the camera. The LCD display will
clear when the motion sensor activates. You can force the LCD display to
clear by pressing the (C KEY).
4) Cuddeback Disarmed – In this state Cuddeback is effectively off and will
not trigger the camera. This state is useful for transporting the Cuddeback
without having Cuddeback trigger the camera or store events. Before
disarming the LCD will prompt [C to Disarm]. You must press the
(C KEY) to disarm the Cuddeback. The Cuddeback will then prompt
[Disarmed]. To rearm Cuddeback press you press the (UP) or (DOWN
KEY) to change the operating mode to Standby, Test, or Live Camera as
desired.
If you press the (M KEY) or (S KEY) during any of the above displays,
Cuddeback will remain in the operating mode displayed.
Automatic Operation. To prevent Cuddeback from being left in the field
in the wrong state Cuddeback features automatic operation. About ten
minutes after your last key press Cuddeback will automatically activate
Live Camera mode. This automatic operation is disabled when Cuddeback
is disarmed.