Dynojet 250: Eddy Current Brake Driveline Upgrade - Manual (Page 14)

Model 250 Eddy Current Brake Driveline Upgrade Installation Guide
D R I V E L I N E U P G R A D E I N S T A L L A T I O N
Install the Driveline and Brace Upgrade
10
U PGRADING AND I NSTALLING THE H OOD
1 Remove the eddy current brake hood from the dyno hood by removing the six
1/4-inch button-head screws and nuts.
2 Secure the rear hood extension to the brake and dyno hoods using four
1/4-20 x 3/4-inch button-head screws and four 1/4-20 nuts.
3 Secure the front hood extension to the brake and dyno hoods using six
1/4-20 x 3/4-inch button-head screws and six 1/4-20 nuts.
Figure 10: Install the Front and Rear Hood Extensions
rear hood
extension
front hood extension