Dynojet 200: High Pressure Blower - Manual (Page 16)

High Pressure Blower Installation Guide
A P P E N D I X A
Installation
A-4
I NSTALLING THE H IGH P RESSURE B LOWER A SSEMBLIES
Repeat the following steps for each blower assembly.
Note: Your blowers may be different than the blowers shown in the following
figures. Installation procedures are the same.
1 Place a poly washer between the pin and the extension arm.
Note: The poly washer is secured to the extension arm with a zip tie. Clip the zip
tie before installing the blower assembly. Refer to Figure A-2.
2 Insert the pin on the blower assembly into the extension arm.
3 If not already installed, secure the hand knobs to the extension arm and to the
blower base.
Note: Your hand knobs may be different than the hand knobs shown in the
following figures.
Figure A-4: Install the Blower Assemblies
blower assembly
poly washer
extension arm
hand knob