Dynojet 200: High Pressure Blower - Manual (Page 18)

High Pressure Blower Installation Guide
A P P E N D I X A
Installation
A-6
M ODIFYING THE E XTENSION A RM A SSEMBLY (F OR P OWER C ARRIAGE O NLY )
When the blower assemblies are used with a power carriage, the following
modifications must be made to the extension arm assembly before mounting the
extension arm assembly to the dyno.
Note: These modifications should be made only when a power carriage is
installed.
1 Remove the four hand knobs from the extension arms.
2 Remove arm A, including the poly washer, and set aside.
3 Remove the bolt, lock washer, flat washer, and spacer securing arm B to the main
bracket, including the poly washer, and set aside.
Note: Arm B is the only arm with a threaded pin.
Figure A-5: Modify the Extension Arm Assembly—Removing the Arms
arm B
arm A
arm A
arm B
hand knob
hand knob
hand knob
hand knob
threaded pin
poly washer
bolt
lock washer
flat washer
spacer
poly washer