Dynojet 224: Pit Installation Guide - Manual (Page 34)

In Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 3
Loading the Vehicle
3-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOADING THE VEHICLE
Use the following steps to load a vehicle on the dyno.
You will need the following parts:
1 Verify your computer is running. Set the dyno brake on by pressing the red button
on the hand held pendant.
2 Drive the vehicle onto the dyno and align the vehicle straight with the dyno.
3 Stop the vehicle when the drive axle is centered on the drum.
Figure 3-1: Center the Drive Axle on the Drum
4 When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, place it in park.
• If the vehicle has a manual transmission, place it in gear.
5 Set the vehicle’s emergency brake.
part description part description
short axle strap, 10M #,
21" (4)
P/N 30AS21
car tie-down, high
performance, 2" x 10" (2)
P/N 500-C10W
long axle strap, 10M #,
6" (4)
P/N 30AS72
car tie-down, 2" x 10" (4)
P/N 500-C10
center drive axle on dyno drum