Dynojet Spring Applied Air Release (SAAR) Brake Assembly - Manual (Page 11)

S P R I N G A P P L I E D A I R R E L E A S E ( S A A R ) B R A K E A S S E M B L Y I N S T A L L A T I O N
The Hydraulic Brake Assembly
Version 1 Spring Applied Air Release (SAAR) Brake Assembly Installation
7
R EMOVING THE H YDRAULIC B RAKE A SSEMBLY
1 Remove the four springs holding the brake head pivot pin to the brake frame rail.
Figure 4: Remove the Springs
2 Use a large flat blade screw driver or small pry bar to pry the brake shoe retainer
out of the brake holder.
Figure 5: Remove the Brake Shoe Retainer
BR012
remove four
springs
brake head
pivot pin
disconnect air
hose or cut air
hose close to
solenoid
brake frame rail
BR019
pry the brake shoe retainer
out of the brake holder
brake
holder