Dynojet Spring Applied Air Release (SAAR) Brake Assembly - Manual (Page 8)

Spring Applied Air Release (SAAR) Brake Assembly Installation
S P R I N G A P P L I E D A I R R E L E A S E ( S A A R ) B R A K E A S S E M B L Y I N S T A L L A T I O N
The Hydraulic Brake Assembly
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
THE HYDRAULIC BRAKE ASSEMBLY
When upgrading to the SAAR Brake Assembly, you will remove the previously installed
hydraulic braking system shown in Figure 2. In order to minimize your exposure to
the fluid used in the hydraulic brake assembly, you will remove the major portion of
the assembly as one piece.
Follow manufacturer precautions for handling brake fluid used in the
hydraulic braking system. Do not breathe vapors, mist, fume or dust. Do not
get in eyes, on skin or clothing. Wear protective gloves or clothing if exposure
conditions warrant. Wash thoroughly after handling. Launder contaminated
clothing before reuse. Use only with adequate ventilation.
Figure 2: Existing Hydraulic Braking System
BR011
solenoid
assembly
hydraulic line
slave cylinder
slave cylinder
mounting
bracket air can
master cylinder
spring
brake clevis
pin
air pressure
regulator