Dyras MM-360 - Manual (Page 5)

EN
MM-360 MM-360
8 9
prescribed for waiting. The manufacturer will not be held liable for any damage caused by
improper use (e.g. improper cleaning, maintenance, dry running), or overloading (e.g. damage
due to accidental or intentional mixing of hard materials).
Please respect the environment when the appliance reaches the end of its life. Electrical products
must not be disposed of with other residential waste because they can damage the natural world
and may be hazardous to human health. You should dispose of the appliance at an appropriate
recycling site or by using a collection service that specialises in electrical appliances.
You may wish to contact the retailer or the manufacturer if you are unable to find convenient local
recycling facilities as they have some legal responsibilities for recycling electrical products.
Please keep this instruction manual. If you give the appliance to anyone else, you must give them
this instruction manual, too!
MAIN COMPONENTS
1. Operating buttons (two speeds)
2. Handle unit
3. Mixing stick
4. Mixing blade
5. Upper element of the beating attachment
6. Lower element of the beating attachment
7. Chopping bowl
8. Chopping knife
9. Chopping attachment lid
10. Power cord (not shown)
POWER SUPPLY
The device must only be plugged into an electric mains supply of 220-240 VAC, 50 Hz. Always
check that the site voltage is identical to that indicated on the device nameplate.
USING OF APPLIANCE
Introduction; applications for the appliance
• The mixing stick attachment can be used for processing liquid foods, blending liquids and mixing shakes,
sauces or baby food.
Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can cause:
- damage, deformation, softening or melting of plastic or rubber parts and casing elements, or
deterioration of electrical insulation.
Following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the appliance. The manufacturer is not responsible if the appliance is stored
inappropriately or contrary to these instructions. You are recommended to have the appliance
serviced regularly by an authorised engineer to keep it working for as long as possible.
• If your appliance is damaged or operates in an abnormal way, immediately stop using it and take it to an
authorised service engineer for checking, repair or adjustment.
• The manufacturer is not responsible for any damage that results from overuse, incorrect operation, incorrect
maintenance, neglecting the information given in the instruction manual or normal wear and tear. In
addition, the manufacturer is not responsible for damage caused by any parts of the appliance breaking or
cracking.
Do not lengthen or alter the mains cable of the appliance. If you need a longer cable between the
appliance and the wall socket, you should buy a standard extension cord from an electrical dealer.
When using an extension cord, be careful not to create a hazard that you or someone else could
trip over.
• You must not disassemble the appliance, remove its cover or to try to repair it. Ignoring this advice could
cause a serious accident. There are no parts in the appliance that can be repaired at home or used for any
other purpose. Never operate the appliance with a damaged mains cable or connector. Do not use the
appliance if it fails to work normally or if it has been dropped or damaged. If the appliance becomes faulty
for any reason or if any moisture is allowed inside, take it to an authorised service engineer for checking
and repair. Only service engineers who have been trained and approved should repair the appliance. The
manufacturer cannot take any responsibility for unauthorised repairs or for any circumstances resulting from
not following the instructions.
Special instructions:
Very Important:
The device has been designed for intermittent operation. The product may be continuously
operated for maximum 1 minute when using any of using any of the attachments. The given
operating periods must be followed by a cool down period of 10 minutes. In case you mix or
chop more dense materials than the average, please reduce the duration of operation. When
using the chopping attachment it is advised not to press the operating buttons continuously, but
intermittently, thus you can achieve more efficient chopping. During shutdown the mains plug of
the device must be always unplugged from the wall socket. Neglecting of the stipulations for this
cool down period, may damage the device and is considered as unprofessional treatment.
The manufacturer will not be held liable for any failure of the appliance caused by or originating
from exceeding the time established for continuous operation or non compliance with the times