Eden N28 - Manual (Page 4)

4
ENHANCE CONTROL
This is a great sounding feature, seldom found on amplifiers at this price level.
The Enhance control is a complex tone Pre-shaping curve that is set up to
optimize your bass sound. It is designed to boost the low frequencies and upper
midrange while at the same time reducing the lower midrange frequencies. The
Enhance control is a quick and easy way to a quality bass tone. To try it out, set
all the other tone controls to flat. Then rotate the Enhance control to around
9:00 to 11:00 for the full effect. This range is typically the best area for
operation. The Enhance can also be used with the other tone controls.
GAIN CONTROL
This control regulates the first amplification stage and controls the gain of the
first stage in the overall system. The compressor automatically tracks the input
level and follows the gain. This is a fixed-threshold type compressor. You
control the compressor threshold by setting the gain higher or lower; depending
on how much compression effect you want. The compressor is also provided
with a bypass switch to defeat the compressor operation if desired. For most
instruments, you should set the control between 9:00 and 3:00 to match your
instrument and playing style to the amplifier.
HEADPHONE OUTPUT/ Aux. Line Out
This jack provides the output for headphones for practicing. If you switch off
the internal speaker, you can use your amplifier to rehearse with just the
headphones. It can also be used as an Aux. line level output to run additional
amplifiers. This output will function as the final master control and the
additional amplifiers will be slaved to it.
D.C. INDICATOR
This indicates that both the D.C. power supplies are operating properly and the
amplifier is turned on.
BACK PANEL FEATURES
VERY IMPORTANT NOTE: The unit is set at the factory to operate at the
correct voltage for your country. It cannot be changed.