Eden N28 - Manual (Page 5)

5
A.C. FUSE
The fuse for US operation is a 2.5 Amp. 5x20 MM slow-blow type fuse. In
Europe, use a 1.2 Amp or 1.6 Amp 240v slow-blow fuse and the appropriate
AC connector for your country. Make certain that your unit is set for the
correct voltage for your country.
HEAVY DUTY PROFESSIONAL USE
The Nemesis N Series Combos are primarily designed for personal practice.
Your unit is designed to be played hard and to hold up well. However, it is not
designed to replace, or to perform as loudly as, the more powerful Eden
separate systems. If you find you are pushing your amplifier so hard that you
are encountering thermal standby and shut down on more than a very
occasional basis, you are pushing the unit well above the intended operating
parameters and should consider stepping up to a bigger rig.
SETTING UP YOUR OWN SOUND
Start by setting the pre-amplifier tone controls to the flat position. Set the
Master volume control to 0. Set all the tone controls to 0. Plug in your Bass and
turn on your unit. Set the Gain control to around 10:00 and move the master up
to around 11:00, or to a comfortable listening level.
To sum things up, you will always have the best results creating a great bass
tone around the natural tone of your instrument. Use the minimum amount of
EQ required to get your sound.
SPEAKER BREAK IN
It is recommended that you play for a few hours at low to medium volume
before you push your new Combo to the max. This will extend the life of the
speaker system.
FOR YOUR SAFETY
Always use a correctly grounded receptacle for your Amplifier A.C. receptacle.
If your fuse should ever need replacement use only the same size and type that
came with your unit from the factory.