Eden VT300A - Manual (Page 3)

3
Front Panel Features
Input Jacks
Designed to accept a standard ¼” mono phone plug. The Passive jack is for
use with low output Basses and passive Basses. The active jack is for higher
output Basses with active electronics.
Overdrive Control
This switch shifts the amplifier into an ultra hi gain mode, suitable for a
wide range of sound textures from clean to fat and all the way to saturated.
With exact control through out the entire range. This works in conjunction
with the gain control. The higher the gain control is set the more distortion
can be generated. This function is also on the foot switch.
Gain Control
This sets the channel gain for the system and lets you match the output level
of your instrument to the amplifier. In the overload mode the gain control
setting determines the amount of overload available.
Multi Q Equalizer
The Multi Q Equalizer circuit uses a four band parametric E.Q.. It has preset
centers, and fixed Qs or bandwidths that vary with center frequency. This is
a very user friendly set up. You can tune in your sound in very quickly
using this simple system. The center frequency spacing follows the natural
content of the music and fits with the instrument very well.
Master Tone Controls
The Master Bass and Treble controls are provided for very fast E.Q. of the
system. They also combine with the Multi Q for even more tone shading.
These are Hi Fi type shelving filters and effect a broad range of tone.