Eden VT300A - Manual (Page 5)

5
Back Panel Features
AC Power Inlet
This is the main AC connection point. It is an IEC type inlet and also serves
as the fuse carrier. Replace the fuse only with the same type and size as the
original.
FX Loop
This loop is located post the tone controls and sit just prior to the amplifier
input.
Tuner Output
This provides a full time output for connection to a tuner.
Direct Recording Output
The direct recording output is fully balanced and has the ground lifted as the
standard configuration. It is configured for both pre and post tone with the
provided switch. The output level can be adjusted with the level control
positioned next to the pre/post switch.
Speaker Impedance Selector
This switch should be selected to match the impedance of the enclosure.
Note: This should be done with the Amplifier turned off.
Speaker Output Connectors
Connect the loudspeaker here. Connect the speaker before turning on the
amplifier. Do not disconnect the speaker while the power is on.