Eden WP100 Navigator (2003) - Manual (Page 11)

11
Tuner Output Send
The tune output send is direct from the Vacuum tube and is not muted
during any of the automatic or manual muting modes. It allows for a tuner to
be plugged in at all times. This output is at the same relative level as the
output of the instrument times 1 or unity Gain.
Foot Switch port (DIN)
The optional foot switch is connected via this port with a standard 5 wire
MIDI cable. One is provided with the foot switch. Do Not use a 4 wire 5 pin
cable to replace the factory standard 5 wire 5 pin cable. The LED lights on
the footswitch follow the panel lights.
Recording D.I. Output
This is controlled on the front panel for both position selection and level.
The ground lift function is separate from the Main D.I. outputs. This output
is capable of + 21 dBm before clipping. It is muted for quite turn on and off.
Foot Switch Controller
The Foot Switch allows hands free access to the front panel controls for:
Mute, Enhance Bypass, Compressor Bypass, and Turbo Boost. Standard
MIDI cable connections at both ends make it easy to change cables in the
event of road damage or loss. The Foot switch is all steel and operates at DC
voltage levels eliminating typical noise and hum problems.
Foreign Voltage setup
Refer this to an Authorized technician ONLY. Any voltage changes made
must be marked at the time of change clearly on the exterior of the unit to
avoid accidental operation at the wrong power settings. This could damage
your unit and void your warranty as well as endanger you personal safety. In
addition the fuse size must be selected to match the voltage selected for
proper safety and correct current sizing. The correct AC standard electrical
code certified cable required by law in that country must be used.