Eden WT1250 - Manual (Page 12)

12
Speaker Connections – If you are using the amplifiers separately, connect a
speaker to each amp. DO NOT use the Bridge Mono speaker connection
and make sure the Bridge Mono switch on the front panel is disengaged.
If desired, you may use a single amplifier to run a single speaker.
If you are using Bridge Mono, DO NOT use the individual amplifier
outputs and make sure the Bridge Mono switch on the front panel is
engaged. You can tell you are in Bridge Mono mode because the indicator
light will be lit. In Bridge Mono, make sure you have connected your
speaker(s) to the Bridge Mode output.
VERY IMPORTANT NOTE: It is very important to make certain you
have set the Bridge Mono switch to the appropriate position and that
you have connected your speakers to the correct outputs. Failure to do
so may result in damage to your amplifier.
EXTREMELY IMPORTANT NOTE: Never, NEVER, NEVER connect
the outputs of the two individual amplifiers to the same speaker cabinet.
This is NOT a clever, inventive thing to do. If you do this, you may
possibly damage your amplifier and/or speaker. Don’t say you weren’t
warned, because you were.
INITIAL SET UP
As bassists, each of us has in our head a concept of our perfect sound. Eden
amplifiers are designed to help you easily achieve the sound you hear inside
you. However, it’s a multi-step process as explained below.
In order to ensure the ultimate in tone, it’s important to follow the procedure
outlined below. Don’t skip steps; don’t jump around. Yes, this may take a
minute or two, but the work is well worth it. Once they’ve done it a few
times, most users can do it time and again in about a minute.
IMPORTANT NOTE: Before you plug in your unit for the first time,
please do the following things. First, turn the power switch to the OFF
position. Check the back of your unit for the correct voltage notation for
your county of operation. Ensure that all speakers are connected to the
correct outputs for your selected mode of operation.