Eden WT800B - Manual (Page 11)

11
Connections – All instrument-level input connections (everything but the
speakers) should be made with high quality shielded cables. The use of
speaker cables for input connections will result in excess noise. Speaker
connections should be made with high quality 16 gauge or heavier
unshielded speaker cables. We recommend 10 or 12 gauge cables. The use
of shielded line or instrument cables for speaker connections can
damage your amplifier. The speaker cable should be as short as possible.
INITIAL SET UP
Before turning your amplifier ON, you must first determine which mode of
operation you wish to use. It is critical to the safety of your amplifier that
you make all connections correctly, and that you set the switches to the
proper position. Failure to do so may result in damage to your amplifier
&/or speakers!
Dual Mono (Stereo) Operation:
Connect speakers to the Left and Right amplifier outputs ONLY. Do NOT
use the Mono Bridge Output. The total impedance of all speakers connected
to each of the amplifiers should not exceed 2 Ohms.
Make sure that the Bi-amp and Bridge Mono switches are both OFF. In
the OFF position, both switches should be flush with the face of the
amplifier.
If you are using stereo effects, the amplifiers will each receive the
appropriate signals. If not, both amplifiers will receive the same signal.
If necessary, use the balance knob to compensate for differences between the
two sets of speakers. If not, it should be in the 12:00 position.
Bridge Mode Operation:
Connect speaker(s) to the Bridge Mono output ONLY. Do NOT use the
individual amplifier outputs. The total impedance of all speakers should not
exceed 4 Ohms.
Engage Bridge Mode by depressing the switch on the front panel. You can
do this using the tip of a pin, a small screwdriver, etc. In the ON position,
the switch should be slightly recessed into the face of the amplifier. When
you turn the amplifier ON, the Bridge Mode Indicator will light.