Eden WT800B - Manual (Page 12)

12
Make sure the Bi-amp switch is OFF, or flush with the panel.
Set the Balance control to the 12:00 position.
Bi-Amp Operation:
Connect the appropriate speakers to each individual amplifier Output.
Engage the Bi-Amp Operation switch. When ON, the switch will stick out
slightly from the face of the amplifier.
Make sure the Bridge Mono switch is OFF, or flush with the panel.
Use the Crossover control to determine which frequencies will go to the
speakers. Because bass frequencies require far more power to reproduce the
treble frequencies, we suggest that you start out low (or left) on the dial. But
it’s only a suggestion. We gave you a crossover control so you could make
your own decision. (You’re welcome!)
If necessary, us the Balance control to balance the volume between the low
and high speakers.
IMPORTANT NOTES: Never, and we mean NEVER, attempt to do
any of the following:
• Use Bi-Amp and Bridge Mono modes at the same time.
• Use Inappropriate Outputs to connect speakers.
• Switch modes of operation while the amplifier is on.
• Connect both individual amplifier outputs to the same speaker.
(That’s what Bridge Mono is for.)
Failure to follow these precautions can cause significant damage to your
amplifier &/or speakers. We’re serious about this. Pay attention.
GETTING A GREAT TONE
As bassists, each of us has in our head a concept of our perfect sound. Eden
amplifiers are designed to help you easily achieve the sound you hear inside
you. However, it’s a multi-step process as explained below.