Eden WTX1000N Navigator User Manual
Page 10
10
Tuner Out Jack This standard 1/4-inch jack is designed to provide a pre-
gain signal for connection to a tuner. It can also be used to provide pre-tone
signal to other devices such as a direct box or console. The signal is enough
to provide adequate signal to virtually every tuner on the market.
FOOTSWITCH FEATURES
Your WTX1000N comes with its own footswitch, allowing you to make
changes on the fly while playing. All corresponding panel switches take
priority over the footswitch. The following functions can be controlled by
the footswitch:
Mute to Tune
Compressor Defeat
Enhance Defeat
Turbo Boost
OPERATING INSTRUCTIONS
Mechanical and Thermal Issues During operation, your amplifier should
always be placed away from sources of moisture or heat. The supplied rack
ears can be used to install your amplifier in a conventional equipment rack
for protection during transportation.
Connections Output connections should be made using balanced or
unbalanced cables. Unbalanced cables are fine for short runs, but for longer
runs, you should use balanced cables. All instrument-level input connections
(Effects Loops, etc.) should be made with high quality shielded cables. The
use of speaker cables for input connections will result in excess noise.