Eden WTX1000N Navigator - Manual (Page 6)

6
Mode Selector Switch – Your WTX1000N can be operated in Stereo or
Bi-amp mode. This switch allows you to choose which mode is used.
Limit Switch – This switch enables the internal stereo Output Limiters to be
engaged with the final Main Outputs. The Limiters are calibrated to two
standard Power Amplifier input voltage requirements: high voltage standard
(such as a Crown amplifier) @ 2.8VRMS and low voltage standard @
1.4VRMS. The selector switch for this is located inside the unit on the right
side of the top front PC board. This should be set up by a qualified service
tech to match the input specifications your particular amplifier at the time of
purchase. Your unit was shipped with the switch in the higher limit position.
This feature gives you the additional safety of having onboard limiting
available for your large power amplifier without the additional cost of an
outboard comp./limiter. With the Limiter switch in the off position, the Main
sends can reach +21 dBm.
NOTE: The limiters will also effect the Headphones and the Stereo D.I.
output.
Side Chain Level Control – This control sets the amount of side chain
effects return that is blended into the original signal.
Crossover Control – Determines the crossover point between amplifiers
when in Bi-Amp Mode. In all other modes of operation, this feature is
defeated.
Aux In Level Control – Sets the level for the stereo Auxiliary Inputs.
Balance Control – Balances power between the two amplifiers: High (or
Left) and Low (or Right). This is useful when using cabinets of different
impedance &/or efficiency.
Output Level Indicators – These give you an easy-to-read display of output
level of your amplifier. For lowest noise, you shou ld set your output as high
as possible without overdriving, and adjust overall system volume using the
level controls on your amplifier.
Master Level Control – Adjusts overall system output and stage loudness.
Headphone Jack – Accepts a standard 1/4-inch stereo headphone plug.