Locking hardware adj, Handle installation, Terrastile door installation instructions – EFCO Terrastile Door User Manual
Page 10
EFCO CORPORATION 6/8/2012 PART NO. YW42
Page 10 of 13
TERRASTILE DOOR INSTALLATION INSTRUCTIONS
SECTION III: Locking Hardware Installation and Adjustment
Handle Installation
Note: Handles and back plates vary in style.
For proper operation, the hardware must be installed in the following order.
Tools required:
A number 2 Phillips screwdriver
A hex-wrench for set screws is provided in the hardware
package.
Notes:
To prevent damage to the handle set while in construction
phase, use the construction handle to operate the door. Lift to
engage multipoint after door is closed. Push down handle to
open the door. (See next page for handle operation.)
Use water to clean. Do not use brass cleaner. It will remove
the protective coating.
1. Apply the backplate gasket (8) to the inside of the exterior backplate
(1). Push gasket firmly onto plate to ensure a tight seal. Apply the
backplate gasket (8) to the inside of the interior backplate (2). Apply
interior (2) and exterior (1) backplates and fasten loosely with the two
screws (6) provided. Note: The screw heads must be on the interior
side of the door.
2. Insert the two piece handle shaft (3) into the handle. Be sure to
orient the shaft (3) as shown. Screw the set screw until flush with
handle using the Allen wrench. See Figure 2. Note: This may seem
to be tight fit. Insert the handle attached to the shaft into the latch
hole.
3. Install the interior handle on the shaft through the latch hole,
pressing tightly to the backplates. Tighten the interior handle set
screw with Allen wrench. Screw until flush with handle.
4. Insert the thumb turn from the interior side of the door until the clear
hole for screw (7) lines up with the threaded hole in the thumb turn
housing. Install the cylinder screw (7) in the screw hole below the
deadbolt in the edge of the door.
5. Tighten the backplate screws.