EFCO Terrastile Door User Manual
Page 2
EFCO CORPORATION 6/8/2012 PART NO. YW42
Page 2 of 13
TERRASTILE DOOR INSTALLATION INSTRUCTIONS
TABLE OF CONTENTS
Page
I. General Notes and Guidelines
3-8
A. General Notes
B. Construction Notes
C. Building Codes
D. General Door Frame Installation
E. Perimeter Anchorage
II. Hinge Adjustment
9
III. Locking Hardware Installation and Adjustment
10-11
IV. Deglazing / Reglazing
12-13
Minimizing Condensation
Note: Please reference EFCO's "Understanding Condensation" brochure which can be obtained through your
EFCO representative.
Condensation will form on any surface when unfavorable conditions (interior temperature and relative
humidity and exterior temperature) are present. When the formation of excessive condensation is a concern, it is
highly recommended that a design professional is utilized to perform an analysis of the shop drawings to
recommend the best possible installation methods. Please contact your EFCO representative for information on
EFCO's Thermal Analysis Services.
Many current installation practices lead to an increase in the possibility of the formation of condensation.
Though not all inclusive, the list of examples below illustrates conditions under which condensation is likely to occur:
1. Bridging system thermal break with non-thermally broken metal flashing or lintels that are exposed
to the exterior
2. System exposure to cold air cavities
3. Interior relative humidity levels not maintained at recommended levels, see EFCO’s “Understanding
Condensation” brochure
4. Inadequate separation between system and surrounding condition at perimeter
5. Product combinations during the shop drawing stage that result in bridging thermal breaks
of one or all products involved