Control panel, Operation – Cuisinart CMW-55 Series User Manual

Page 8

Advertising
background image

8

2. Do not remove the legs from the

bottom of the oven.

3. Leave a minimum clearance of 12

inches (30cm) above the oven. A
minimum clearance of 3.0 (8cm)
inches is required between the
oven and any adjacent walls. One
side must be open.

4. Remove any protective film found

on the microwave oven cabinet sur-
face.

5. Do not remove the light brown mica

cover “wave guard” that is attached
to the oven cavity to protect the
magnetron.

6. Blocking the intake and/or outlet

openings can damage the oven.

7. Operation of microwave oven may

cause interference to other elec-
tronic equipment in the vicinity.

8. Plug your oven into a standard

household outlet. Be sure the volt-
age and the frequency are the
same as the voltage and the fre-
quency on the rating label.

WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance. If improperly installed near or
over a heat source, the oven could be
damaged and the warranty would be
void.

The accessible surfaces may be hot
during operation.

CONTROL PANEL

OPERATION

1. SETTING THE CLOCK

When the microwave oven is
plugged into an outlet, the LED will
display 0:00.

1. Press 0/CLOCK. LED will display

00:00.

2. Press the number keys to enter

the correct time as correspond-
ing 00 is flashing. Time entered
can be 1:00–12:59.

For example, for 10:12, press 1, 0,
1, 2 in turn.

3. Press START/+30SEC. to confirm.

Time will appear in LED.

Note:
To see the time of day while the
timer is showing cooking time,
press 0/CLOCK. To see the power
level currently in use, press
POWER. The LED will resume previ-
ous display after three seconds.

Advertising
This manual is related to the following products: